VIDEO
HIGHLIGHT
Log InSign up
IEC104 Data Acquisition | IIoT Gateways
SummaryTranscriptChat

IEC104 Data Acquisition | IIoT Gateways

Gateway Device Configuration for iHC104 Protocol

Initial Setup and Connection

  • The session begins with an introduction to configuring a gateway device using the iHC104 protocol. The speaker emphasizes the importance of successfully connecting to the device through configuration software.
  • It is crucial to ensure that the device's IP address matches the corresponding network port, especially since there are two network ports belonging to different networks.

Configuration Steps

  • After confirming the connection, users should click on "署标" (label).
  • Select "ISC104" from the options and assign a name for identification purposes.
  • Input the device's IP address followed by its port number in the respective fields.

Address Verification

  • Default settings can typically remain unchanged; however, it’s important to verify specific parameters related to data points.
  • The first type of data point mentioned is "摇性" (single-point status), which requires careful attention during setup.
  • Users must confirm public addresses associated with IC14 protocol devices, ensuring accuracy as this step is critical for successful communication.

Data Point Management

  • Public addresses may vary; thus, it's essential to check if they start at zero or one. This verification helps avoid misconfigurations.
  • If multiple devices need to be collected simultaneously, users can add several entries at once during configuration.

Finalizing Configuration

  • Review corresponding single-point status and control data points before proceeding.
  • Ensure that all necessary data points are accounted for and correctly configured based on their public addresses starting typically from 16385.
  • Once all configurations are complete, click on "写入配置" (write configuration), then wait briefly before reconnecting using the configuration software.

Monitoring Success

  • If all references for the IC104 device are correct, users will see successful data collection from the gateway.
  • Finally, monitoring tools can be accessed to observe real-time data collection results.