Cara memasang sensor Gerak dengan Kontaktor

Introduction and Overview

In this video, the speaker shares a tutorial on how to use a motion sensor with a contactor for moonlight sensing. The tutorial includes information on setting up the circuit and adjusting the sensor's settings.

Moonlight Sensor Circuit Setup

• The circuit setup involves using a motion sensor with one or more loads.

• If the load is large, it is recommended to use a contactor to minimize power consumption.

• The circuit consists of two lamps and one prediction device.

Motion Sensor Settings

• The motion sensor has different settings, including auto mode, manual mode, and off mode.

• The delay time for turning off the lights can be adjusted from 10 seconds to 15 minutes using a tester or thin screwdriver.

• There are options for setting the sensitivity of the sensor based on ambient light conditions (daytime or nighttime).

Contactors and Terminations

• Contactors are necessary when dealing with high-power loads.

• The circuit includes neutral and live terminations.

• The input voltage for the circuit is 10V AC.

Simulating Motion Detection

• By simulating motion detection, it can be observed that the lights turn on immediately when movement is detected within the range of the sensor.

• The range of the motion sensor depends on its installation height and can cover several meters.

Conclusion

The video concludes by emphasizing that this setup provides an efficient way to control lighting based on motion detection.